Use and Care / Installation Manual

8 31-2000814 Rev. 1
Installation
2
MOVE THE RANGE INDOORS
1. Tilttherangeforwardontheskid.
2. Lift the toekick out of the foam base.
3. Drive the blade of the hand-truck beneath the foam
block.
IMPORTANT:Donotremovethebasefoamblockwhile
the hand-truck is in use. Place the hand-truck blade
underneath the base foam block and transport the range
to the final location.
4. Attach the hand-truck straps around the unit.
IMPORTANT:Placethehand-truckstrapsbelowthe
ovendoorhandles.Toavoiddamagingthesidepanels,
placeapadbetweenthehand-truckandtherange.
5. Tilttherangetolowerthehand-truckwheelsoffthe
skid.
6. Place the appliance runners on the floor at the left
and right sides in front of the opening.
IMPORTANT: The runners provide a surface for
rollingtherangeintothefinalpositionandwillprotect
the floor finish. The runners must be removed before
leveling the range.
7. Move the range indoors. Position the range in front of
theinstallationlocation,ontotherunners.
Toekick
Toekick
Insert Blade Under
the Foam Block
You may need to remove
the front of the foam block
tofitthroughthedoorway.
Hand-Truck
StrapsBelow
Oven Door
Handles
Range
Opening
Runners
for Rolling
the Range
into
Position