Use and Care / Installation Manual

31-2000814 Rev. 1 9
Installation
3
INSTALL ANTI-TIP DEVICE
Toreducetheriskoftippingtherange,therangemust
be secured by a properly installed anti-tip bracket. See
installationinstructionsshippedwiththebracketfor
complete details before attempting to install.
To check if the bracket is installed and engaged
properly,lookunderneaththerange.Theanti-tipbracket
should be inserted into the opening on the anti-tip brace
on the range. If the bracket arm misses the brace to the
leftorright,orthebracketarmisnotprotrudingthrough
thebraceopening,thebracketmustbereinstalled.
Iftherangeispulledfromthewallforanyreason,
alwaysrepeatthisproceduretoverifytherangeis
properly secured by the anti-tip bracket.
Ifyourrangehasnoanti-tipbracket,call1.800.626.8774
to receive one at no cost.
Iftheanti-tipdevicesuppliedwiththerangedoesnot
fitthisapplication,usetheuniversalAnti-TipDevice
WB2X7909.
ReadtheAHAMAnti-TipSafetyBrochurepackedwith
the bracket.
Anti-Tip Parts Provided
■Attachtheanti-tipbraceontothebottomoftherange
intherecessedarea.Install2hexscrews(provided)
through the brace and into the range.
NOTE: This anti-tip device may be installed on the
opposite side of the range.
■MeasureandmarkDimensionA(seetablebelow)
from the left (or right) side of the installation location.
Ifthecountertophasanoverhang,addthatdimension
to Dimension A.
■Placetheanti-tipbracketagainstthefloorandbackwall
atthemarkedlocation.Markscrewholesforfastening
thebrackettothewallsoleplateandthefloor.
■Drill1/8”pilotholesata20°angle.
■Securethebrackettothewalland/orfloorwithatleast
2woodscrews(provided).
For Concrete or Cement Construction: You must use
appropriatefasteninghardware(notprovided).
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back such that the foot is engaged.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
Tip-Over Hazard
WARNING
Anti-Tip Bracket
Anti-Tip Brace
4WoodScrews
AHAM Anti-Tip
Safety Brochure
3HexHeadScrews(2
required,1extra)
Alternate Brace
Position
HexScrews
Anti-Tip Brace
Anti-Tip Bracket
A
Wall Sole Plate
Range A
36” 5-1/16”