Quick Reference Guide

ADDITIONAL MATERIALS YOU WILL
NEED
• Clean Release Masking Tape – 2” width (min)
Built-In Wall Oven Flush Inset Installation Instructions
30” 27”
Single Oven Double Oven Single Oven Double Oven
CTS70DM CTD70DM CKS70DM CKD70DM
Cutout A Minimum cutout width with 1/8” side reveals 30 30 27 27
B Minimum cutout height with 1/8” top reveal, 1/4” bottom reveal 29 53-3/8 29-3/16 51-1/2
C Minimum cutout depth 24-13/16 24-13/16 24-13/16 24-13/16
Cleats D Bottom cleat thickness – extends full depth of cabinet 11/16 1/2 11/16 11/16
E Side cleat thickness 3/4 3/4 1 1
F Top cleat thickness 1-1/16 1-1/16 7/8 1-1/8
G Setback – all cleats 1-5/16 1-5/16 1-5/16 1-5/16
H Depth - side and top cleats 2-1/2 2-1/2 2-1/2 2-1/2
Electrical
Junction Box
J Vertical from upper right corner 5-1/4 5-1/4 5-1/4 5-1/4
K Horizontal from upper right corner 9-1/2 9-1/2 9-1/2 9-1/2
Please use this information along with the normal installation instructions to achieve the ÀXVKLQVHW installation
of your appliance.
PREPARATION
1. Measure your cabinet to ensure all dimensions
match the specific flush inset requirements for your
model (see chart).
2. Apply Clean Release Masking Tape to all cabinet
faces for protection while installing the unit. For
each edge of the cabinet opening, start tape 1/2”
in from cabinet face and wrap around front face
to protect edges. Ensure tape extends around the
entire opening - top, bottom, and both sides.
INSTALLATION
1. Follow main instructions for product installation.
2. Remove Clean Release Masking Tape before
driving the mounting screws and trapping it in place.
3. Complete remaining steps of installation.
49-2000532 Rev. 0 12-18 GEA
ELEC.
C
G
A
F
E
B
D
K
J
H
Top
Cleat
Side
Cleat
Bottom
Cleat
Side View Front View
Allow 1/8” clearances from side edges of oven door.
Top View
All dimensions shown are in inches.