Owner's Manual

49-1000081 Rev. 1 23
INSTALLATION INSTRUCTIONS
Installation Instructions
STEP 12 START ICEMAKER
CAUTION
Avoid contact with the moving
parts of the ejector mechanism, or with the heating
element (located on the bottom of the icemaker) that
releases the cubes. Do not place fingers or hands
on the automatic ice making mechanism while the
refrigerator is plugged in.
• Slide the power switch to ON.
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the
feeler arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, slide the switch to OFF.
Feeler Arm
Power
Switch
Icemaker
STEP 11 CONNECT POWER,
CLOSE GRILLE PANEL
• Open the grille panel.
• Plug in the power cord (if necessary) by reaching
into the opening next to the water filter. The water
filter guard will need to be removed for access
(some models). Remove the 3 screws holding it in
place. If access is still too tight, remove the 2 screws
holding the water filter bracket and move aside. Plug
in the power cord. Secure the bracket and guard
with the original screws.
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are
on.
• The temperature controls are preset at 37°F (3º C)
for the fresh food section and 0°F (-18º C) for the
IUHH]HU
$OORZKRXUVWRVWDELOL]HEHIRUHPDNLQJ
adjustments.
STEP 10 CONNECT WATER
SUPPLY
WARNING
Connect to potable water supply
only.
• Locate and bring the tubing to the front of the
cabinet.
• Turn the water on to flush debris from the line. Run
about a quart of water through the tubing into a
bucket, then shut off the water.
Copper Tubing:
6OLSD´QXWDQGIHUUXOHSURYLGHGRYHUERWKHQGV
of the copper tubing. Insert the tube into the union
fitting on the unit and tighten the nut to the union.
• Turn on the water to check for leaks.
SmartConnect
Tubing:
NOTE: The only Café-approved plastic tubing is
supplied in the SmartConnect
Refrigerator Tubing
kits. Do not use any other plastic water supply line
because the line is under pressure at all times. Other
types of plastic may crack or rupture with age and
cause water damage to your home.
SmartConnect
5HIULJHUDWRU7XELQJ.LWVDUHDYDLODEOH
in the following lengths:
¶P:;;
¶P:;;
¶P:;;
¶P:;;
• Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression nut
until it is just hand tight.
• Tighten one additional turn with a wrench.
2YHUWLJKWHQLQJFDQFDXVHOHDNV
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with the toekick installation.
Water Filter
Guard in Front of
Electric Outlet
Access
Bracket
Screws
Screws
Refrigerator
Water Supply
House
Water Supply