Spec sheet

Specification Created 1/15
Listed by
Underwriters
Laboratories
To insure accuracy, it is best to make a
template when cutting the opening in the counter
Electrical junction box 16" MIN.
below countertop
Cooktop
29-3/4"
21-3/8"
19-1/4"
28"
19-5/8"
to 19-3/4"
2-1/2" MIN.
Required
28-1/2" to
28-5/8"
1-3/4" MIN.
to rear wall
CHP9530SJ
4-5/8" at baffle near center of
unit (except when installed
above an approved wall oven)
and
3-1/4" at rear of air intake
13" MAX. depth of unprotected
overhead cabinets (when no
hood or microwave is installed)
30" MIN. from countertop to
unprotected cabinet (when
no hood or microwave is
installed)
2" MIN. clearance
to side wall from cut-out
on both sides of cooktop
15" MIN. height from countertop
to nearest cabinet (including
light rails) on both sides of
cooktop
Important: Requires a 5" free area between
the bottom of the cooktop to any combustible
material, i.e., shelving. Free area not required
when installing wall oven underneath cooktop.
Refer to installation instructions. Requires
a 15" minimum from cooktop to adjacent
overhead cabinets. Units are furnished with a
48" flexible armored cable.
note: 30" induction cooktops are approved for
use over select GE 27" and GE 30" Single Wall
Ovens and Warming Drawers. Refer to cooktop
and wall oven/warming drawer installation
instructions packed with product for current
dimensional data. If installed with a GE Telescopic
Downdraft System, consult both the cooktop
and downdraft installation instructions packed
with product before installing.
Cooktop gas/
electric supply may need to be re-routed to install
downdraft.
The countertop cutout requires
23-1/2" minimum flat countertop surface and 25"
minimum total countertop depth. In addition,
other clearances to front edge of the countertop
must be considered. Before installing, consult
installation instructions packed with product for
current dimensional data.
DImensIons anD InstallatIon InformatIon (In Inches)
chp9530sJ
GE Ca
Series 30" Built-In Touch Control Induction Cooktop
KW Rating
240V 7.3
208V 6.4
Amperage
240V 30.8 Amps
208V 30.8 Amps
†Note: Check local codes for required
breaker size
approxImate cookIng DImensIons
For answers to your Monogram
®
or GE appliance
questions, visit our website at geappliances.com
or call GE Answer Center
®
service, 800.626.2000.

Summary of content (2 pages)