Installation Guide

Café
™
20.2 Cu. Ft. Fully Integrated Installation
French-Door Bottom Freezer
CIP36NP2VS1
FLOORING
For proper installation, this refrigerator must be placed on a level
surface of hard material that is at the same height as the rest of the
flooring. This surface should be strong enough to support a fully
loaded refrigerator, or approximately 1500 lbs.
NOTE: Protect the finish of the flooring. Cut a large section of the cardboard
carton and place under the refrigerator where you are working.
WATER AND ELECTRICAL LOCATIONS
The opening must be prepared with the electrical and water supply
located as shown.
FINISHED RETURN OF 6" REQUIRED
A minimum 6" (15.2) finished return matching cabinet exterior
recommended on interior on all sides and top at front of opening
ADDITIONAL SPECIFICATIONS
A 120 volt, 60Hz, 15 or 20 amp power supply is required. An
individual properly grounded branch circuit or circuit breaker is
recommended.
Install a properly grounded 3-prong electrical receptacle recessed
into the back wall. Electrical must be located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not recommended. Water line can enter
the opening through the floor or rear wall. The water line installed should be
1/4" O.D. copper tubing or GE SmartConnect™ tubing between the cold water
line and water connection location. The line should be long enough to extend
to the front of the refrigerator. Installation of an easily accessible shuto valve
in the water line is required.
SIDE VIEW
25" (63.5)
FRONT VIEW
ELEC W
36" (91.4)
84"
(213.4)
18"
(45.7)
9"
(22.9)
6"
(15.2)
2 1/2"
(6.4)
9"
(22.9)
8"
(20.3)
6"
(15.2)
Finished
Return
Back
DIMENSIONS AND INSTALLATION
(FULLY INTEGRATED INSTALLATION)