Manual

49-2000685 Rev. 0 15
1. Slide the left corner into opening and push power
cord into the hole leading to the outlet location.
Thread the cord through as drawer is being pushed
back into the opening.
If the outlet is installed inside the opening, plug
the cord into the outlet. In this location, the excess
power cord should be coiled and taped to the right
side of the unit. Make sure the cord does not get
trapped by the drawer.
NOTE: Insure that the power cord does not contact
the hot surfaces on the bottom of ovens, cooktops,
or any other appliance.
2. Push the drawer back until the front flange is flush
to the cabinet front.
3. Open the drawer fully.
4. Drill pilot holes through the holes in the overlapping
frame, one on each corner.
5. Drive wood screws provided into each corner.
INSTALLING WARMING DRAWER
INSTALLATION INSTRUCTIONS
Installation Instructions