Use and Care Manual

49-2000706 Rev. 0 13
Installation Preparation
INSTALLATION PREPARATION
INSTALLATION DIMENSIONS
The hood duct covers can be adjusted for different
ceiling heights depending on the distance between
the bottom of the hood and the cooktop (distance
X). See Installation Height Table on the next page.
DUCT COVER REQUIREMENTS
Duct cover kits must be purchased separately.
We recommend that the vent hood and duct cover
(if used) be on site before final framing and wall
finishing. This will help to accurately locate studs,
ductwork and electrical service.
• Duct cover accessory comes with a lower and
upper duct cover and installation hardware.
• The installation hardware includes mounting
brackets to secure duct covers to the wall.
• For vented installations, recirculation holes can be
hidden by installing the upper duct cover upside
down.
• See table below for duct cover kit part numbers
based on finish.
NOTE: Duct Cover Kits CX8DC9SPDS and
CX8DC9SPWM only support vented installation
mode.
X = Distance from hood to cooktop. (Varies
depending on the installation) Required 24”
minimum over electric range or 30” minimum over
gas range. The recommended maximum is 36".
Typical Range
NOTE: 36" for typical electric range
and 38" for gas range.
Upper Duct
Cover
5" min
27" max
19-1/2”
18”
X
36”
or
38"
Lower Duct Cover
Required Min & Recommended Max Ceiling Height
Examples for 10’ Duct Cover Kit (Vented)
Electric Gas
X = 24”
Y = Min 8’ 2”
Max 9’ 10”
X = 30”
Y = Min 8’ 10”
Max 10’ 6”
X = 36”
Y = Min 9’ 4”
Max 11’ 0"
Model # Duct Cover Kit #
Max Ceiling
Installation
30” & 36"
Model (Matte
Black)
CX8DC9SPDS 8’ 4”
CX10DC9SPDS 11’ 1/4”
CX12DC9SPDS 13’ 4”
30” & 36"
Model (Matte
White)
CX8DC9SPWM 8’ 4”
CX10DC9SPWM 11’ 1/4”
CX12DC9SPWM 13’ 4”
Y