installation Guide

Installation Instructions
15
Gasket
Machine
Screw
Door
Panel
Use UPPER
hole at the top
Hole Plug
Cover
Use LOWER
hole at the
bottom
INSTALLING THE DOOR PANEL (Cont)
If the door swing is going to be changed please complete prior to installing the door panel. See page 13.
Attaching the Door Panel
The panel will be held on by 6 sheet metal screws and 2
machine screws.
1. Remove the gasket from the inside of the door and retain
for later use.
2. Remove any plastic covering the stainless steel panel.
3. Place the door panel onto the outside of the door and
secure it with 2 machine screws in the left center and
right center of the door.
4. Fasten the panel to the door using the 6 sheet metal
screws. In the hinge opening area opposite the hinge
side, use the outermost screw holes only.
5. Place the covers over the hinge opening areas and
secure each cover to the door using a sheet metal screw
and washer.
6. Insert hole plug over screw installed in step 5.
7. Return the gasket to its original position.
8. Attach the door to the cabinet using the original screws.
IMPORTANT: In some situations the door can open too far
and damage adjacent cabinets. To prevent this, insert a
Stop Pin (in hardware packet) into the provided hole in the
top and bottom hinges. Drive the pin into the hole until the
head is flush with the hinge.
9. Slide the hinge covers from the hardware packet over
each hinge.
10. Attach the side covers from the hardware packet over
the hinge by peeling off the covering over the adhesive
and placing it over the side of the hinge.
Note: If the unit is being built-in a screw can be used to
secure the unit to the cabinet in place of installing the
side covers.
11. Return the kickplate and front service panel to their
original positions and attach to the cabinet using the
original screws.
Hinge Cover
Side Cover
Stop
pin