Instruction manual
7
English
1
2
Programming the quantity of coffee in a cup
• Raise the lever to open the capsule compartment.
• Insert the capsule, pressing it gently into place.
• Close the lever fully.
• Place a cup or mug under the dispensing spout.
• Press and hold the desired coffee button (through the entire cycle).
• On reaching the desired amount in your cup or mug, release the button. Now the button is
programmed. The quantity of coffee dispensed can be programmed from a minimum
of 30ml up to a maximum of 250 ml.
• Recommended Programming/ Current Programming:
- 30ml Espresso shot (A Button)
- 60ml: Espresso shot (B Button)
- 120ml: Tea and Hot Water (C Button). (Maximum 250ml)
• Raise the lever to eject the used capsule into the drawer.
• Close the lever.
Turning on the appliance - Daily and Regular Usage
• Fill the tank with fresh, still water.
• Switch on the appliance by pressing the power on/off button.
• The Buttons A-B-C blink at the same time; the machine is warming up. When the buttons
turn on and remain steadily lit, the appliance is ready for use.
General operating indications
DESCALING SIGNAL:
• When warning light D blinks YELLOW/ ORANGE and the machine emits 3 beeps
(after which will remain lit), it is advisable to perform the descaling cycle (See section:
Descaling).
HEATING: (this will typically take 45-50 sec):
• Buttons A-B-C blink at the same time.
WHEN THE WATER RUNS OUT DURING OPERATION:
• When warning light D blinks RED and the machine emits 3 beeps, the water tank is empty.
• Fill the water tank with fresh, still water.
• Press one of the buttons A-B-C (making sure there is no capsule in the chamber). Wait
for the machine to complete the priming cycle.
• When buttons A-B-C turn on and remain steadily lit, the machine is ready for use.
IF THE LEVER IS RAISED:
• If the lever is raised during the delivery of a product, the machine can emit jets of hot
• water. Risk of burns!
• The D indicator light blinks RED and a beep is emitted. The appliance will immediately
stop dispensing.
• Close the lever.
• Press a button A-B-C to reset the alarm.
• The appliance is ready for use.
A
B
C
D