Instruction manual

English

Dispensing hot water

WARNING! The tube for dispensing hot water reaches very high temperatures:

Danger of scalding! The tube must only be handled using the special rubber

grip. After each use, clean the tube with a damp cloth.

• Place a metal container or cup under the hot water dispensing pipe.

• Turn the control lever forwards. Start dispensing hot water.

• To end dispensing, set the control lever back to its central position.

• Remove the container of hot water.

Preparing Steamed Milk / Dispensing steam

WARNING! During preparation there may be some brief splashes of hot water

and the steam dispensing tube reaches very high temperatures. Danger of

scalding! The tube must only be handled using the special rubber grip. After

each use, clean the tube with a damp cloth.

• Place a metal container under the hot water dispensing pipe.

• Turn the control lever backward; this discharges any water left in the circuit.

• After a few seconds, only steam will start to come out; return the control lever to a central

position. Empty the container.

• Half-ﬁ ll a cup/jug with milk, then immerse the steam tube in the cup.

• Turn the control lever backwards to start dispensing steam.

• Move the cup in a slight circular motion to ensure the milk is evenly heated.

• When preparation is complete, return the control lever to a central position.

• Finally add completed Steamed/Frothed milk to your beverage of choice.

NOTE: Do not lift the lever while steam is being dispensed. If the lever is lifted,

steam dispensing will stop immediately, warning light D begins to blink RED and

the machine beeps. To reset the machine, close the lever, return the control lever to

a central position and press any button.