Installation Guide

FOR WARRANTY ISSUES OR QUESTIONS, CONTACT CAHABA AT [phone].
©2017 CAHABA. ALL RIGHTS RESERVED.
2
PULL-DOWN KITCHEN FAUCET
Installation Instructions
DETERMINE INSTALLATION PREFERENCES
This faucet can be installed as 4 hole installation with the escutcheon or
as 2 hole installation with ange.
FLANGE INSTALLATION:
1. Shut off water supplies & remove old faucet.
2. Before installation, ensure the ange is placed on the bottom of the new
faucet assembly.
3. Insert faucet body through the hole in the ange.
ESCUTCHEON INSTALLATION:
1. Shut off water supplies & remove old faucet.
2. Screw the bolts into the escutcheon (a).
3. Ensure the gasket is pressed into the escutcheon before the escutcheon
is installed over the three holes in the sink (b).
4. From underneath the sink, hand tighten the mounting nuts. Do not
overtighten (c).
5. Insert faucet body through the hole in escutcheon.
INSTALL THE FAUCET
1. Install the plastic washer (a) and metal washer (b) onto the threaded
mounting shank (c). Thread the nut onto the mounting shank. Lock the
nut into position by tightening the screws. Do not overtighten.
2. Push the quick connector rmly upward and attach it to the receiving
block (d). Pull down moderately to ensure the connection has been
made. If it is necessary to remove the quick connector, squeeze the tabs
on the quick connector and then pull down to disconnect.
3. After connecting the hose, install the weights at the point of the hose
marking “weights here” (e).
FLANGE INSTALLATION OPTION
ESCUTCHEON INSTALLATION OPTION
(a) Screw bolts
into escutcheon.
(b) Press the escutcheon
into the gasket.
(c) Hand tighten
mounting nuts.
Place flange on bottom
of faucet assembly
before setting in sink.
SECURE THE FAUCET
(a) Plastic washer
(b) Metal washer
(c) Mounting shank
(d) Push up
to attach
the quick
connector
(e) Attach the weights
ATTACH CONNECTORS AND WEIGHTS