Specification

FOR WARRANTY ISSUES OR QUESTIONS, CONTACT CAHABA AT [phone].
©2017 CAHABA. ALL RIGHTS RESERVED.
5
30 IN. SQUARE GRATE LINEAR SHOWER DRAIN
Installation Instructions
PREPARE FLASHING (CONTINUED)
DRAIN AT FULL CURB OR PARTIAL CURB ENTRY
1. Flashing must turn up the walls a minimum of 3” above shower curb
and 6” above oor in showers without curbs (H).
2. Prior to installing ashing, install pre-formed outside corners (available
separately) following manufacturer’s instructions. 2 per side.
3. Measure width of shower oor across drain base. Measure up and over
curb. Lay ashing at. Measure and mark ashing.
4. Cut, fold and crease to proper size and t (K).
X IMPORTANT: Do not secure flashing at this time.
X NOTE: Preformed curbs may also be used. See manufacturer’s
instructions.
DRAIN AT CURB-LESS ENTRY
1. Flashing must turn up the walls a minimum of 3” above shower curb
and 6” above oor in showers without curbs.
2. Measure width of shower oor across drain base.
3. Lay ashing at. Measure and mark ashing. Cut, fold and crease to
proper size and t (L).
X IMPORTANT: Do not secure flashing at this time.
DRAIN ON CENTER
1. Flashing must turn up the walls a minimum of 3” above shower curb
and 6” above oor in showers without curbs.
2. Measure width of shower oor across drain base.
3. Lay ashing at. Measure and mark ashing. Cut, fold and crease to
proper size and t (M).
X IMPORTANT: Do not secure Shower Pan Liner at this time.
(H) FLASHING FOR DRAIN AT CURB ENTRY
(L) FLASHING FOR DRAIN AT CURB-LESS ENTRY
6" min.
2" min.
(M) FLASHING FOR DRAIN ON CENTER