Specification
FOR WARRANTY ISSUES OR QUESTIONS, CONTACT CAHABA AT (866) 837-2550.
©2017 CAHABA. ALL RIGHTS RESERVED.
5
48 IN. SQUARE GRATE LINEAR SHOWER DRAIN
Installation Instructions
PREPARE FLASHING (CONTINUED)
DRAIN AT FULL CURB OR PARTIAL CURB ENTRY
1. Flashing must turn up the walls a minimum of 3” above shower curb
and 6” above oor in showers without curbs (H).
2. Prior to installing ashing, install pre-formed outside corners (available
separately) following manufacturer’s instructions. 2 per side.
3. Measure width of shower oor across drain base. Measure up and over
curb. Lay ashing at. Measure and mark ashing.
4. Cut, fold and crease to proper size and t (K).
X IMPORTANT: Do not secure flashing at this time.
X NOTE: Preformed curbs may also be used. See manufacturer’s
instructions.
DRAIN AT CURB-LESS ENTRY
1. Flashing must turn up the walls a minimum of 3” above shower curb
and 6” above oor in showers without curbs.
2. Measure width of shower oor across drain base.
3. Lay ashing at. Measure and mark ashing. Cut, fold and crease to
proper size and t (L).
X IMPORTANT: Do not secure flashing at this time.
DRAIN ON CENTER
1. Flashing must turn up the walls a minimum of 3” above shower curb
and 6” above oor in showers without curbs.
2. Measure width of shower oor across drain base.
3. Lay ashing at. Measure and mark ashing. Cut, fold and crease to
proper size and t (M).
X IMPORTANT: Do not secure Shower Pan Liner at this time.
(H) FLASHING FOR DRAIN AT CURB ENTRY
(L) FLASHING FOR DRAIN AT CURB-LESS ENTRY
6" min.
2" min.
(M) FLASHING FOR DRAIN ON CENTER