Instruction Manual

100 Tutorials
Tutorial 1—The Basics
A. Loop On/Off B. Loop start time C. Loop end time D. Set loop to selection time
E. Loop/Auto Shuttle properties
To loop over the entire project, do the following:
1. In the Loop toolbar, click the Loop Start time. The time display changes
to an edit box with spin controls.
2. To loop over the entire project, the loop must start at 1:01:000. If the
Loop Start time is not already set to 1:01:000, use the keyboard or spin
controls to enter this value. To set it to 1:01:000, click the Loop Start
time, enter 1 and press Enter.
3. In the Loop toolbar, click the Loop End time.
4. Press F5 to open the Markers dialog box.
5. Select the marker named <End> and click OK. The Loop End time is
set to the end of the project.
6. Click the Loop On/Off button to enable looping.
7. Click Play.
When looping is enabled, the Time Ruler displays special flag markers that
indicate the loop start and end times. You can drag these markers to
change the loop start and end times.
A. Loop Start B. Loop End
To turn looping off, click the Loop button again.
Looping Over a Section of the Project
Maybe you would like to practice one section of the project over and over.
Or, maybe you'd like one section played repeatedly so you can practice an
EAB CD
AB