Instruction Manual

1045

Dim Solo Mode

New Features in SONAR 7

The EQ settings are copied from the source track/bus to the target track/

bus. The target EQ will automatically be enabled if it was not already

enabled.

This command is undoable, so you can quickly and easily revert to a track/

bus’ previous EQ settings.

Note: You can only copy settings from an EQ that is enabled.

A. Hold down the Ctrl key and left-click in the source EQ plot B. While still holding

down the Ctrl key and left mouse button, drag the mouse cursor to the target EQ plot

and release the mouse button C. The source EQ plot is copied to the target EQ plot

Dim Solo Mode

Normally when you solo a track/bus in SONAR, the tracks or buses which

are not soloed are essentially muted. Dim Solo is a mode in which non-

soloed audio tracks/buses are still audible but at a reduced level. The

default gain reduction is -6dB, but can also be configured for -12dB and -

18dB.

Dim Solo is useful when you want to focus on a specific track but you still

want to edit/mix the track in context with the entire mix. This allows you to

hear all tracks while the soloed track stands out from non-soloed tracks.

Note: Dim Solo mode only applies to audio tracks and buses, not MIDI

tracks.

To Enable/Disable Dim Solo

When Dim Solo is enabled, non-soloed audio tracks will play at a reduced

gain rather than 0 gain (mute).

To enable/disable Dim Solo mode, do one of the following:

Before copy After copy