Instruction Manual

1071
Overview
Cyclone
In the Pad Inspector there are the following controls:
Control… Description…
Output You can select from one of 16 audio outputs or use the
Mix Only setting to use the Master out.
MIDI In You can set which MIDI channel the pad group
responds to. Each pad group could have a unique MIDI
Input channel.
Pad Root This setting is read from the file when it is imported. The
first loop sets the Pad Root value for each additional
loop.
Velocity—Low The minimum velocity value that triggers the pad group.
Velocity—High The maximum velocity value that triggers the pad group.
Key Map—Unity The MIDI note value at which the loop plays at the Pad
Root pitch. This value is assigned to a loop when it is
imported. You can change the Unity value in the Pad
Inspector or in the Key Map view.
Select an
audio output
Click to toggle on/
off Latch mode
Click to enable
tails for current
track
Click to force
Cyclone to follow
SONAR’s Pitch
markers