Instruction Manual

1183
Output Bus Meter Options-Peak + RMS
Menu Reference
Output Bus Meter Options-Peak + RMS
Available in the Playback Meter Options, Record Meter Options, and Mains
Meter Options submenus, this command sets the meter to Peak + RMS.
For more information about Peak + RMS meter display, see Metering.
Output Bus Meter Options-Show Labels
This command toggles on/off the meter labels.
Output Bus Meter Options-Hold Peaks
This command causes a meter to hold the most recent peak for a short
time. The peak volume level recorded by the meter is marked by a small
white line which remains for a moment if lock peaks is not checked or until
the end of playback or recording if Lock Peaks is checked.
Output Bus Meter Options-Lock Peaks
This command when checked and the Hold Peaks is also checked causes
the peak to be locked at its highest point on the meter until the end of
playback or recording.
Playback Meter Options-Pre Fader
This command sets the meter to measure the volume level in the signal
path prior to entering the fader.
Output Bus Meter Options-Pre Fader
This command sets the meter to measure the volume level in the signal
path prior to entering the fader.
Playback Meter Options-Post Fader
This command sets the meter to measure the volume level in the signal
path after exiting the fader.