Instruction Manual

1335
Go dialog
Dialog Reference
• Remove—to remove a folder from the to-be-scanned list, first select the
folder, and then click the Remove button.
• Folder defaults—click this button to open a dialog of folder options.
These settings will set options for all the VST plug-ins in all the folders
listed in the VST Scan Folders window.
VST Scan Options
This group of commands controls the following options:
• Scan for VST Plug-ins On Startup—if this option is checked, the folders
listed in the VST Scan Folders window are searched for new plug-ins
whenever you start SONAR. Any previously unscanned plug-ins are
then scanned.
• Re-scan Failed Plug-ins—checking this option causes any plug-in(s)
that didn’t scan correctly to be rescanned during the next scan.
• Re-scan existing plug-ins—checking this option causes plug-in(s) that
did scan correctly to be rescanned during the next scan. This is a way
to implement any changes you’ve made to the Folder defaults settings.
VST Scan
The commands in this section control the following options:
• Scan VST Folders—click this button to immediately scan the folders
listed in the VST Scan Folder(s) window.
• Reset All VST Plug-ins—click this button to remove all scanning
records and settings from all your VST plug-ins. Use this button if you
want to completely start over.
Go dialog
The Go-Time command opens the Go dialog box, which allows you to jump
to a new Now Time. Additionally, the Go dialog opens when you right-click a
transient marker on a track with AudioSnap enabled and choose Move to or
Stretch to.
The Go dialog box has only the following field:
To Time
In this field, fill in the time you want to move to according to the table below.
You can click the spin controls (plus-minus buttons) to move forward or
backward one tick at a time. When you click OK, the Now time becomes the
time in the To Time field.