Instruction Manual

136 Tutorials
Tutorial 5—Editing Audio
Bouncing Tracks
When you finish editing a certain number of audio tracks, you can conserve
memory and simplify your mix by bouncing (combining) some tracks down
to one or two tracks. You can choose to include any effects and automation
in the new track that are on the tracks that you want to combine, greatly
reducing the load on your CPU.
Let’s bounce, or combine our two percussion tracks together:
1. Make sure no time range is selected by clicking in the Clips pane
outside of any clips.
2. Select the tracks that you want to combine: in this case, Maracas and
Congas. To select multiple tracks, hold down the Ctrl key while you
click each track’s track number. You can also solo tracks instead of
selecting them.
3. Click the Snap to Grid button to turn it on (the Snap to Grid setting is
still set to Measure).
4. In the Time Ruler, select measures 18 through 28.
5. Use the Edit-Bounce to Track(s) command to open the Bounce to
Track(s) dialog box.
6. In the Destination field, choose <8> New Track.
7. In the Source Category field, choose Entire Mix.
8. In the Channel Format field, since our two original percussion tracks
are in stereo, choose Stereo. This way we preserve their stereo quality.
9. In the Source Bus(es) field, make sure the name of the sound card that
the relevant tracks use to play back on is highlighted.
10. In the Mix Enables field, make sure everything is checked. By checking
the Track Mute/Solo option, you make sure that SONAR only mixes
down the unmuted tracks. If any tracks are soloed, this option causes
SONAR to mix down only the soloed tracks.
11. Click OK.
SONAR creates a new, stereo track that combines both percussion tracks.
Now you can archive the old percussion tracks so that they don’t consume
memory. Do this by right-clicking each track number and choosing MSR-
Archive from the popup menu.
Go to the next tutorial: Tutorial 6—Using Groove Clips.
Back to Tutorials.