Instruction Manual

192 Controlling Playback
Changing Track Settings
Show Layers button Hides or shows track layers.
Minimize/restore track
button
Collapses track to minimum possible height, or restores it to
the size it was before it was minimized.
Maximize/restore track
button
Expands track to maximum possible height, or restores it to
the size it was before it was maximized.
Vol (volume) The current volume level for the track, ranging from -INF
(silent) to +6 dB (maximum volume).
Pan The stereo distribution of the output, ranging from 100% left
(hard left) to 100% right (hard right); a value of “C” indicates
sound that is centered left-to-right. On stereo tracks, pan
acts as balance.
Trim (volume trim) Volume Trim is a pre-fader control which allows the fine
tuning of a single track’s volume.
For example, let’s say you have four tracks, three tracks
have their volume fader set to 0 dB while the fourth track’s
fader is set to +10 dB. You want to group the faders and do
a slow fade out, but the slightly higher level of the fourth
track causes its volume to be higher in relation to the other
tracks towards the end of the fade out. To balance the fader
levels, reduce the fader level for the fourth track to 0 dB and
raise the Volume Trim value for that track to +10 dB. The
resulting volume levels for the project are the same, but now
you can group the faders and perform a fade out with no
track standing out disproportionately at the end of the fade
out.
Input The input source for the track, used in recording
Output The output bus through which the track is played
Send Enable Activates a send module, which sends a copy of the track
signal to a bus.
Send Level Controls volume of audio data sent by this send module.
Send Pan Adjusts the send pan setting.
Parameter... What it means...