Instruction Manual

297
Arranging Tracks
Arranging
2. If you want to insert audio tracks, do the following:
• Fill in the number of audio tracks you want to insert in the Audio
section’s Track Count field.
• Pick a main audio output for the tracks in the Main Destination field.
• If you want the main output that you chose to be the default output
for new audio tracks, enable the Set as Default Bus checkbox. You
can also choose the default bus by right-clicking a bus, and
choosing Set as Default Bus from the popup menu.
• If you want your new audio tracks to contain a Send module that
outputs to a specific bus, choose the bus in the Send field. If you
choose None, the new audio tracks will not contain a Send module.
3. If you want to insert MIDI tracks, do the following:
• Fill in the number of MIDI tracks you want to insert in the MIDI
section’s Track Count field.
• Pick a MIDI output for the tracks in the Port field.
• Pick a MIDI output channel for the tracks in the Channel field.
4. Click OK to insert your tracks, or click Cancel to cancel the operation.
Your new tracks appear below any pre-existing tracks, with new audio
tracks appearing above new MIDI tracks.
Note: you can also choose the default output bus for new audio tracks by
right-clicking a bus, and choosing Set as Default Bus from the popup
menu.
Configuring the Display of Tracks in the Track
View
There are several commands in the Zoom tool dropdown menu that allow
you to configure the appearance of your tracks in the Track view. You can
use these commands to zoom in or out, show or hide any combination of
tracks, and revert back to previous display settings. The following table lists
each of these commands and provides an explanation of each: