Instruction Manual

422 Editing MIDI Events and Controllers
Event Inspector Toolbar
•Time
•Pitch
•Velocity
• Duration
• Channel
To Display a Note’s Properties in the Event Inspector
Toolbar
• Select a note.
If you select multiple notes, the Event Inspector toolbar displays the
note value if all selected note values are the same. If the note values
are different, the Event Inspector does not display anything.
To Change a Note’s Properties Using the Event
Inspector Toolbar
1. Select a note.
2. In the appropriate Event Inspector toolbar field, change the value. See
the table below for a description of valid value entries for each field in
the Event Inspector toolbar.
Event
Inspector
Field…
Valid Values…
Time Any valid M:B:T time value. Separate values with a
colon or a space. For example, measure 2, Beat 3, Tick
720 would be written as 2:3:720.
Pitch Note names (C0 through G10) and note numbers (0
through 127) are valid in this field. Also, you can use a
modifier to raise or lower the value by a number of half-
steps. To raise the pitch by 2 half-steps, type +2 and
press enter. To lower the pitch by 2 half-steps, type -2
and press enter.
Velocity A velocity value or modifier value are valid in this field.
Valid velocity values are 0 through 127. Valid modifier
values are +/- 0 through 127.
Duration A PPQ value.