Instruction Manual

500 Editing MIDI Events and Controllers
MIDI Effects (MIDI Plug-ins)
To Apply the Arpeggiator to MIDI Data
1. Select the data to be affected.
2. Choose MIDI Effects-Cakewalk FX-Arpeggiator from the Process
menu or from the popup menu to open the Arpeggiator dialog box.
3. Set the arpeggiator parameters, as described in the table above.
4. Click OK.
SONAR applies the specified arpeggio effect to the selected data.
Play thru The disposition of the notes you play to specify the
arpeggio. Checked plays the original notes.
Unchecked filters out the original notes.
Specify output range The range over which the arpeggio plays. Checked
specifies that the arpeggiator repeats notes at each
octave over the entire specified range. Unchecked
specifies that the arpeggiator includes only the notes
you actually play.
Lowest note The MIDI number of the lowest note of the arpeggio.
Numbers run from 0 to 127.
Span (Notes) The number of half-steps in the range. Numbers run
from 12 to 127.
Use chord control The chord you specify. Checked specifies that the
arpeggiator infers the chord from the notes played in
the range. It identifies the chord in the Chord
recognized box and uses it to play arpeggios for notes
outside the range.
Lowest note The MIDI number of the lowest note the arpeggiator
uses for chord recognition (0 to 126).
Span (Notes) The number of half-steps in the range. Numbers run
from 1 to 127.
Chord recognized The chord the Arpeggiator recognizes and plays.
Parameter/Option... Meaning...