Instruction Manual

575

ReWire

Software Synthesizers

Note: Always close your ReWire applications before closing SONAR or a

SONAR project.

See also:

Mixing Down ReWire Instruments

Automating ReWire Instruments

ReWire Troubleshooting Guide

Routing MIDI Data to ReWire Instruments

Some ReWire applications can create large numbers of instruments. You

can send a track’s MIDI data to any of these instruments by selecting the

specific instrument in the MIDI channel menu of the relevant track.

To Send MIDI Data to a Specific ReWire Instrument

1. In the SONAR MIDI track that contains the recorded MIDI data you

want to send, make sure that the Output menu is set to the correct

ReWire device.

2. Then use the Ch menu in the same track to choose the instrument you

want to send to. This also works if you just want to use this track to play

your MIDI controller through a particular instrument in the ReWire

application.

Mixing Down ReWire Instruments

To either mix down or bounce ReWire instruments to new audio tracks, use

the same procedures as for synths.