Instruction Manual

592 Mixing
Signal Flow
You control the mixing and playback of an audio track as follows:
To do this... Do this...
Add a real-time audio
effect to the track
Right-click in the FX bin and select an effect
from the list (for more information, see Using
Real-Time Effects)
Remove an effect Select the effect and press Delete or right-click
and select Delete.
Send audio data from
the track to a bus
Insert a send in the track controls by right-
clicking in the track controls and selecting
Insert-Send-[name of bus you want the data
to go to]. Click the FX tab at the bottom of the
Track pane, and then click the track’s bus
enable button so that it turns green, and set the
Bus Send Level and Bus Send Pan (for more
information, see Stereo Buses)
Mute the track Click the Mute button
Solo the track Click the Solo button
Arm the track for
recording
Click the Arm button
Set the Pan level Adjust the Pan control
Set the Send Pan to be
the same as the bus that
the send feeds into
Right-click the Send Pan control and choose
Follow Track Pan from the popup menu. This
setting is only active when the send has the
same interleave as the bus that the send feeds
into, and is set to "Post Fader." If enabled, the
Send Pan control no longer affects the output.
Set the Volume level Adjust the Volume fader
Select the output Click the dropdown arrow in the Output field and
choose one from the list
Select the input Click the dropdown arrow in the Input field and
choose one from the list