Instruction Manual

594 Mixing

Signal Flow

A. Pre-fader: output level to Bus 2 is not affected by the track’s volume fader B. This

track is routed to Aux 1 and Aux 2 C. Bus enable button: must be lit to send track

data to bus D. Post-fader: track’s volume fader controls output level to Bus 1

The audio in each bus is processed by the input gain and pan controls

(main output buses don’t have these controls), then processed by any real-

time effects you have patched, sent through the bus output level and pan

controls, and then sent to the designated main out, in stereo. You can also

insert a send control on a bus, and send the bus signal to another bus, or

route the output of a bus to another bus.

At each main out, all audio data from audio tracks and buses that were

routed to that main are mixed together. Finally, the data passes through

each main’s master volume fader.