Instruction Manual

628 Mixing
Using V-Vocal
• The yellow line is the edited Pitch curve and this line is the actual
sounding pitch.
• The red line is the original Pitch curve and this line cannot be edited.
• The green dot is a Node. Nodes are automatically assigned to the start
and end of the edited region. You can select the specific region
between the nodes if you click the yellow line between the nodes.
• The white horizontal line is called Center Pitch. Center Pitch is used as
a baseline for increasing or decreasing vibrato or for pitch correction.
To Change the Pitch of a Selected Region
1. Use the Arrow tool to select the part of the yellow line that you want to
transpose (make sure that the Pitch button in the edit mode section is
enabled).
The selected region turns blue to show that it is selected.
2. Drag the yellow line up or down.
Nodes appear automatically when you shift pitch.
Tips:
• Ctrl-dragging snaps the pitch to the pitch correction grid. Shift dragging
moves the pitch by 100 cent increments.
• You can also edit pitch by dragging a node up or down.