Instruction Manual

630 Mixing
Using V-Vocal
To Draw Straight Line Pitch Changes
1. Click the Line tool.
2. Draw a line on the graph.
To Correct Pitch
1. Select the region you want to correct by using the Arrow tool.
2. Select the notes that you want the selected region to become by
clicking notes on the Keyboard button. The selected notes should be
light blue. The deselected notes are dark blue. When you click the
Correct button, the selected area conforms to the light blue notes on
the keyboard. You can also click the note names in the Select Pitch
Correction field to select notes. Note that light blue note names are
selected, grey note names are not selected, and red note names are
bypassed.
Note: to display different octaves, drag the vertical scroll bar that is at
the right side of the graph up or down.
3. Set the amount of pitch correction you want by adjusting the Note knob.
100 cents is equal to a half-step. Between 70 and 100 is a good place
to start.
4. If the selected region has any unstable pitch areas such as portamento,
you can adjust the Sense knob, which adjusts pitch correction
sensitivity. Pitch correction gets stronger if you increase the value. 30 is
a good starting point. If the selection has vibrato, try 0 to 30.
5. Click the Correct button. The pitch in the selected region moves to the
target pitches (the light blue notes on the keyboard).
To Conform Pitches to a Scale
1. Use the Arrow tool to select the region where you want to correct
pitches.
2. Click the Scale button so that it is enabled (light blue).
3. Click a Maj or Min button to select a major or minor scale, respectively.
4. Click a note on the Keyboard button to select the root note of the scale.
The notes of the scale you selected turn light blue on the Keyboard
button.
5. Click the Correct button.
The selected area conforms to the light blue notes on the keyboard.