Instruction Manual

677
Panning in Surround
Surround Mixing
To Change the Width
• In the large surround panner, drag the Width slider.
To Change the Front/Rear Balance
• In the large surround panner, drag the FrntRrBl slider left to reduce front
level, or right to reduce rear level.
To Change the LFE Send Level
• In either the large or small surround panner, drag the LFE slider.
Note: double-clicking any surround panner control will reset the control to
its default value, which for the LFE control is -INF.
To Solo or Unsolo the LFE Channel
• In the large surround panner, click the LFE Solo button.
To Isolate a Signal in One Speaker
• In the large surround panner, drag the Width slider to 0, the Focus
slider to 100, and then drag the Angle slider until the sphere icon is
directly in front of the correct speaker.
Or
• Press the desired Numeric Keypad key that represents the speaker
position (7=L, 8=C, 9=R, see Keyboard Shortcuts).
To Group Panner Controls
• In the large surround panner, right-click each slider that you want to add
to the group, and choose Group-”n” from the popup menu.
Now you can move a single slider, and all sliders in that same group move
synchronously.
Note: if you group sliders that are in the same surround panner, you can no
longer move the markers that represent those sliders’ values. You can only
move a grouped marker by moving its associated slider.
Keyboard Shortcuts
The following shortcuts allow you to control a surround panner from the
keyboard:
Shortcut... Function...
Alt+drag Constrains to angle