Instruction Manual

82 Introduction
SONAR Basics
4. In the Current Toolbar Buttons field, select a component that you do not
want to see in the toolbar, and click the Remove button to move the
component to the Available Toolbar Buttons field.
5. Repeat step 4 for any additional components you would like to remove.
6. If you would like to move a toolbar component to a different location in
the toolbar, select the component in the Current Toolbar Buttons field,
and click the Move Up button or the Move Down button to change the
button’s location in the toolbar.
7. Repeat step 7 for any additional components.
8. If you want to restore the toolbar to its default appearance, click the
Reset button.
9. Click Close when you want to close the dialog.
To create a toolbar:
1. Use the View-Toolbars command, and check one of the User “n”
options.
A toolbar appears, with a default set of controls.
2. Right-click the toolbar, and choose Customize from the popup menu to
open the Customize Toolbar dialog.
3. Customize the toolbar the in the same way as the previous procedure.
To rename a toolbar:
1. Right-click the toolbar, and choose Rename from the popup menu to
open the Rename Toolbar dialog
2. Fill in the New Name field, and click OK.
Now when you open the Toolbars dialog, the name you chose is listed in
the dialog.
To dock or undock a toolbar:
• To dock a toolbar horizontally, drag it to the top or bottom of the
interface.
• To dock a toolbar vertically, drag it to the left or right side of the
interface.
• To undock a toolbar, drag it to the part of the interface where you want
it, or entirely away from the interface.