Instruction Manual

886 External Devices
Connecting and Disconnecting
7. In the Controllers/Surfaces dialog, make sure that the WAI Display
check boxes and the ACT Indicators check boxes are enabled, and
click Close.
To Load the Correct Edirol PCR Memory Preset
1. Press the Memory button on your Edirol PCR.
2. Use the INC and/or DEC buttons to enter “1”, which is the correct
preset to control SONAR (only when you are using the default PCR
factory presets).
3. Press the Enter button on your PCR.
Now that your controller/surface is connected, you can see which tracks
and/or buses are being controlled by it by looking at the colored markings
(the WAI display: see The WAI Display for more information) in SONAR’s
interface. Open your controller/surface’s property page by double-clicking
the WAI display, or by clicking the Controller/Surface Properties button
on the Controllers/Surfaces toolbar (use the Views-Toolbars-Controllers/
Surfaces command), or by choosing the controller/surface from the Tools
menu.
Once the Edirol property page is open, press F1 on your computer
keyboard to open the help file for the property page.
See:
The WAI Display
ACT
Connecting and Disconnecting
If you are not using an Edirol PCR controller, use the following procedures
to connect or disconnect your controller/surface:
To Enable MIDI Input and Output Drivers
1. Use the Options-MIDI Devices command to open the MIDI Devices
dialog.
2. In the Inputs pane on the left side of the dialog, make sure that the MIDI
Input driver or drivers that your controller/surface uses are enabled
(highlighted).
3. If you have a bi-directional controller/surface (one that both sends and
receives data in order to control a software application), also make sure