Instruction Manual

914 External Devices
Working with StudioWare
To Adjust a Single Control in a Group
1. Hold down the Shift key and drag the control to a new value.
The range for the control is adjusted so that its current position corresponds
with the current position of other controls in the group.
Example: To Set Two Faders for a Crossfade
1. Move the two faders to their midpoint.
2. Click on the first fader, and then Ctrl-click on the second to create a
group.
3. Move both faders to their highest position.
4. Shift-drag the second fader to its lowest position.
5. Drag the first fader to its lowest position.
6. Shift-drag the second fader to its highest position.
These two controls are now grouped so that they move in opposite
directions.
The minimum and maximum values of the faders look like this:
To set faders that are always the same distance apart, set the ranges
something like this:
Fader... Starting
value...
Ending
value...
#1 0 127
#2 127 0
Fader... Starting
value...
Ending
value...
#1 0 63
#2 64 127