Reference Guide

1467
Step Sequencer View
View Reference
1. Click the Options button .
A pop-up menu appears.
2. Select Set Default Velocity for Steps from the pop-up menu.
The Set Default Velocity for Steps dialog appears.
3. Specify the desired velocity value and click OK.
To compress or expand all note velocities in a row
1. Right-click a row and select Adjust Velocity Multiplier from the pop-up menu.
The Adjust Velocity Multiplier dialog appears.
2. Do one of the following:
• To compress the note velocities, specify a value below 1.00.
• To expand the note velocities, specify a value above 1.00.
To add/remove a flam
• Double-click the desired step.
Flammed steps are drawn with a dividing marker halfway through the step.
To adjust a row’s flam timing, click the row’s Select button to show the Controllers pane, then
adjust the Flam knob as desired.
A. Flammed step B. Normal steps
To add slide (portamento) to notes
To create a smooth slide between two pitches, you must insert controller events in the Controllers
pane. For details, see To create a smooth slide (portamento) between pitches.
To specify the likelihood that a note will play (randomize)You can specify the
probability of whether an enabled note will play or not. By default, all enabled notes have a
Probability value of 100%, which means the notes always play. To reduce the likelihood that a note
will play, decrease the Probability value.
1. Click a row’s Select button.
The Controllers pane appears below the row.
Note: The default velocity setting is global and only affects new notes.
A
B