Reference Guide

349

Fades and Crossfades

Arranging and editing

To Permanently Delete Slip-edited Data

1. Select the clips that contain the slip-edited data you want to delete.

2. Select the Edit > Apply Trimming command.

SONAR permanently deletes the slip-edited data from the clips you selected.

Slip-editing Multiple Clips

You can slip-edit multiple clips at the same time.

To Slip-edit Multiple Clips at Once

1. Make sure all clips are not loop-enabled.

2. Select the clips you want to slip-edit.

3. Move your cursor over the beginning or end range of the selected clips until the blue clip handle

appears.

4. Drag the boundary to the desired location and release.

Fades and Crossfades

Fades are a gradual increase or decrease in volume at the beginning (fade-in) or end (fade-out) of a

clip. A crossfade is when one clip fades out while another fades in. There are two ways to create

fades and crossfades in SONAR: offline (destructive) and real-time (non-destructive). To create

fades and crossfades offline, see “Applying Fades and Crossfades Offline” on page 565.

See:

Using Fades and Crossfades in Real Time

You can create real-time fades and crossfades in the Track view’s Clips pane. Real-time fades and

crossfades do not change the data in the clip. SONAR reads the fade-in, fade-out, or crossfade in

the clip and adjusts the gain accordingly. You can edit the crossfade’s start time and end times. You

can set the type of fade-in or fade-out you want to use as a default:

• Linear. A straight line, raising or lowering the volume at a steady rate.

• Slow Curve. A curved fade which starts to change the volume slowly at first and then rapidly

increasing (fade-in) or decreasing (fade-out) the volume.

• Fast Curve. A curved fade which starts to change the volume quickly at first and then rapidly

decreasing (fade-out) or increasing (fade-in) the volume.