Reference Guide

423
Working Groove Clip audio
Working with Loops and Groove Clips
The clip appears in the Loop Construction view.
2. Click the Follow Project Pitch button.
To Transpose a Groove Clip by Semitones
Follow this procedure to transpose a Groove clip by any number of semitones.
1. Double-click the clip you want to transpose to the project’s pitch.
The clip appears in the Loop Construction view.
2. If the Follow Project Pitch button is enabled, click it to disable it.
3. In the Pitch (semitones) field, enter the number of semitones you want to transpose the clip by.
A negative number in the Pitch (semitones) field transposes a clip down. A positive number in
the Pitch (semitones) field transposes the clip up.
To “Fine Tune” a Groove Clip
Follow this procedure to make slight pitch changes to a clip.
1. Double-click the clip you want to transpose to the project’s pitch.
The clip appears in the Loop Construction view.
2. In the Fine Pitch (cents) field, enter the number of cents you want to adjust the pitch. You can
enter a number from -50 (transpose the pitch down by a quarter tone) to 50 (transpose the pitch
up by a quarter tone).
To Edit the Slicing Markers in a Groove Clip
The table below describes how to create and edit the slicing markers in the Loop Construction view.
For more information about slicing markers, see “Slicing Markers” on page 415.
Editing Slices
Each slice (space between the slicing markers) can be adjusted in the Loop Construction view. You
can adjust the following slice attributes:
•Gain
To do this Do this
Add a slicing marker Move the mouse cursor to the Markers bar, at the
beginning of a transient and double-click.
Delete a slicing marker
Select the Eraser tool and click on a marker.
Move a slicing marker Click and drag a marker
Reset slicing markers to original positions
Click the Default All Markers button .
Table 78.