Reference Guide

606

Mixing

Signal Flow

A. Pre-fader: output level to Bus 2 is not affected by the track’s volume fader B. This track is routed to Aux 1 and

Aux 2 C. Bus enable button: must be lit to send track data to bus D. Post-fader: track’s volume fader controls

output level to Bus 1

The audio in each bus is processed by the input gain and pan controls (main output buses don’t

have these controls), then processed by any real-time effects you have patched, sent through the

bus output level and pan controls, and then sent to the designated main out, in stereo. You can also

insert a send control on a bus, and send the bus signal to another bus, or route the output of a bus to

another bus.

At each main out, all audio data from audio tracks and buses that were routed to that main are mixed

together. Finally, the data passes through each main’s master volume fader.

See:

Main Outs

Signal Flow