Reference Guide

631
Sidechaining
Mixing
Bouncing Tracks
Bouncing to Clips
Sidechainable Vintage Channel VC-64 plug-in
The Vintage Channel VC-64 plug-in supports sidechaining (see “Sidechaining” on page 629). When
an instance of Vintage Channel VC-64 is inserted in a project, you can assign audio track, bus and
send outputs to its sidechain input.
Each Compressor and EQ can be configured to listen to the sidechain input. The sidechain signal is
always applied to the last input(s) of the VC-64.
Sidechain controls
The VC-64 has three buttons that affect sidechaining:
Key (for each compressor). Enabling sidechaining on one of the compressors will send the
sidechain input(s) to the level detector of that compressor. This function compresses the signal
based on the sidechain level rather than the primary input level.
Listen. Enable to listen to the compressor’s sidechain signal instead of the ordinary output.
Key (for each EQ). Enabling sidechaining on one of the equalizers will replace its normal input
(according to its routing) with the sidechain signal.
Note: The Vintage Channel VC-64 plug-in is only available in SONAR Producer.
Note 1: When you enable Key on one of the compressors, the internal compressor sidechain
(detector chain) is fed from the external sidechain inputs. When you enable Listen you will hear
what's on the compressor’s sidechain regardless if this comes from the external sidechain inputs
or not. If you want to hear the external sidechain you must enable both Key and Listen on one
of the compressors.
Note 2: If Listen is enabled on both compressors only the sidechain of Compressor 2 will be
heard.