Reference Guide

655
Using the Per-track EQ
Mixing
To Enable or Disable the EQ in a Track or Bus
• Click the EQ Enable button.
To Enable or Disable a Band
• Click the Enable/Disable Band button that’s at the top of each band’s controls.
To Choose the Filter Type for Each Band
• Click the Filter Type menu, and choose a filter type.
To Set Frequency, Gain, and Q for Each Band
• In the Track or Bus Inspector, in the band that you want to configure, drag the frequency slider,
gain slider, or Q slider, respectively, to the left or right. In the Console view, rotate the buttons that
correspond to each parameter. There are tooltips for each control.
To Hide or Show the Plot (Graph)
• In the Console view, click the Plot button. In the Inspector, click the Display button, and click
Plot.
To Change the Plot Resolution
• In the Console view, right-click the Plot button and choose options. In the Inspector, click the
Module Options button, choose EQ and Plot, and choose options.
To Open the EQ Interface
• Double-click the Plot.
To Turn Off Bands 5 and 6
• If you are using bands 5 and/or 6, you can turn these bands off by right-clicking the Plot, and
choosing Reset Hidden EQ Parameters.
To copy EQ settings
SONAR lets you easily copy EQ settings from one track/bus (source) to another track/bus (target)
when using the integrated per-channel EQ in the Console View.
1. CTRL-click on the source EQ plot area and hold down the left mouse button.
2. While still holding down the CTRL key and left mouse button, drag the mouse cursor over the EQ
plot area on the target track.
3. Release the left mouse button and CTRL key.
The EQ settings are copied from the source track/bus to the target track/bus. The target EQ will
automatically be enabled if it was not already enabled.