Reference Guide

886
External Devices
Euphonix EuCon control surface support
To Save a Preset
• Type a name in the Preset box, then click the Save (floppy disk) button.
Euphonix EuCon control surface support
SONAR supports the Euphonix EuCon protocol, which allows SONAR to be controlled by Euphonix
surfaces such as the MC and CM408 series.
To enable EuCon support in SONAR
1. Follow your Euphonix surface’s instructions for physically connecting the Euphonix surface to
your computer and configure the Euphonix software.
2. In SONAR, use the Options > Controllers/Surfaces command to open the Controllers/
Surfaces dialog.
3. Click the Add Controller/Surface button , which opens the Controller/Surface Settings
dialog.
4. In the Controller/Surface field of the Controller/Surface Settings dialog, select EuCon
Controller.
5. Click OK to close the Controller/Surface Settings dialog.
6. In the Controllers/Surfaces dialog, make sure that the WAI Display check boxes and the ACT
Indicators check boxes are enabled, and click Close.
For more information about using the EuCon Controller surface, see the separate EuCon Controller
online help (open the EuCon Controller plug-in and press F1).
See also:
To Connect a Controller/Surface to SONAR
The WAI Display
The WAI display (short for Where Am I) is a group of colored markers to show you which tracks and/
or buses are currently being controlled by which controller/surface. Each controller/surface uses
different colored markers.
In the following picture controller/surface 1 (blue markers) is controlling tracks 2-5, and controller/
surface 2 (red markers) is controlling tracks 7-14. You can drag the markers to different groups of
Note: It is not necessary to select any input or output ports.