Reference Guide

896
External Devices
Working with StudioWare
SONAR creates a group from the selected controls.
To Remove Controls from a Group
1. Hold down the CTRL key and click on any control in the group.
SONAR removes the control from the group.
To Adjust a Single Control in a Group
1. Hold down the SHIFT key and drag the control to a new value.
The range for the control is adjusted so that its current position corresponds with the current position
of other controls in the group.
Example: To Set Two Faders for a Crossfade
1. Move the two faders to their midpoint.
2. Click on the first fader, and then CTRL-click on the second to create a group.
3. Move both faders to their highest position.
4. SHIFT-drag the second fader to its lowest position.
5. Drag the first fader to its lowest position.
6. SHIFT-drag the second fader to its highest position.
These two controls are now grouped so that they move in opposite directions.
The minimum and maximum values of the faders look like this:
To set faders that are always the same distance apart, set the ranges something like this:
Fader Starting value Ending value
#1 0 127
#2 127 0
Table 184.
Fader Starting value Ending value
#1 0 63
#2 64 127
Table 185.