Manualshelf

Reference Guide

ManualsBrandsCakewalk ManualsSoftwareCakewalk Sonar - X1
1161116211631164116511661167116811691170
1170
External devices
Working with StudioWare
If you record a snapshot of control positions on a track that contains linked clips, the clips remain
linked, and the snapshot applies to all copies of the linked clip.
If you are not happy with the automation data you recorded, you can always use the Edit > Undo
command to remove it.
The automation data you record using a StudioWare panel can be displayed and edited using either
the Notes pane in the Piano Roll view or the Event List view. For more information about the
Controller pane, see “Controllers, RPNs, NRPNs, and Automation Data” on page 716. For more
information about the Event List view, see “The Event List view” on page 718.
To record a snapshot while playback is stopped
1. Set the Now time to the point in the project where you want the settings to take effect.
2. Move the controls to the settings you desire.
3. Click .
SONAR records a snapshot of the current control settings.
If the Now time is the very beginning of the project, then the snapshot will change the track
parameters to match the controls in the panel instead of recording automation events.
To record a snapshot while playback is in progress
1. Make sure the button in the StudioWare toolbar is not pressed so that Update is disabled.
2. Change the Now time to a few bars or seconds before the time you wish to take the snapshot.
3. Start playback.
4. When you have reached the appropriate time, click on the Snapshot button.
SONAR records a snapshot of the current control settings.
To record control changes in real-time
1. Make sure the button in the StudioWare toolbar is pressed so that Update is enabled.
2. Make sure the button in the StudioWare toolbar is pressed so that Recording is enabled.
3. Set the Now time to a few bars or seconds before the time at which you want to record control
movements.
4. Click or press SPACEBAR to start playback.
5. Adjust the controls as you wish while playback is in progress. Each time you adjust a control, the
Record tool is activated.
Note: Do not press the Record button in the Control Bar’s Transport module!