Reference Guide

150
Tutorial 7 – Mixing and adding effects
Follow these steps to create your reverb send from the Console view:
1. We want to add this send to all tracks, so go to Edit > Select > All to select all tracks.
2. Right-click on one of your tracks in the Sends section of the strip and choose Insert Send
Assistant. If you don’t see the Sends section in your Console view, click the Console view
Modules menu and make sure Sends/Bank/Patch is selected.
The Insert Send Assistant appears.
3. Configure the Send Assistant as follows:
• Click New Bus. This will create a new reverb bus instead of routing the tracks to an existing
bus.
•Select Stereo
• In the Name box, type Reverb.
• Click Choose Effect and select Audio Effects > Sonitus:fx > Reverb.
• Make sure Pre Fader is not selected.
• Select the Show Effects Property Page check box.
• In the Bus Output list, select Master.
4. Click OK.
The Reverb property page appears.
5. Set the Reverb control to 0.0 dB and the Dry control to -Inf..
Notice that a send control named Reverb has been added to each track. To enable or disable a
send, click the On/Off button located on each track’s Send control.