Reference Guide

1705
Step Sequencer view
View reference
See:
“Step sequencer interface” on page 1697
“Working with rows” on page 1706
“Working with steps” on page 1709
“Working with Controller events” on page 1717
“Working with patterns” on page 1719
“Working with Step Sequencer clips” on page 1723
“Keyboard shortcuts” on page 1704
When focus is on steps, toggle step or tie on/off; for buttons, turn on/off ENTER
When focus is on a step, allow velocity adjustment SHIFT+ENTER
For spinner controls, increase/decrease value; fine adjust for knobs + / - (PLUS and MINUS)
Coarse adjust for knobs [ / ] (square brackets)
Toggles the Audition (Play) button for the view CTRL+SHIFT+SPACEBAR
When focus is on the steps pane, move focus to the next enabled note on
the same row
TAB
When focus is on the steps pane, move focus to the previous enabled note
on the same row
SHIFT+TAB
Shift the active row's steps by 1 step and wrap first step to the end ALT+LEFT ARROW
Shift the active row's steps by 1 step and wrap the last step to the beginning ALT+RIGHT ARROW
Load a pattern CTRL+ALT+L
Save the current pattern CTRL+ALT+S
Enable/disable MIDI step recording CTRL+R
Go to previous step when step recording COMMA (,)
Go to next step when step recording PERIOD (.)
Note: You can also use a mouse wheel to adjust the value of the control that has focus. When
adjusting note velocities, hold down the SHIFT key for fine control.
If a knob has focus, you can press ENTER or F2 and type the desired value in an edit box.
Action Key
Table 263.