Reference Guide

1760
View reference
Console view
Snap-to positions
Faders and knobs have snap-to positions. To set the snap-to position, move a control to the desired
snap-to position, right-click the control, and choose Value > Set Snap To = Current.
To arm a channel strip for automation recording
Click the channel strip’s Write Automation button.
To disable automation recording for the channel strip, click the Write Automation button again.
To arm a single control for automation recording
Right-click the control and choose Automation Write Enable on the pop-up menu.
To disable automation recording for the control, choose Automation Write Enable on the menu
again.
Read Automation and Write Automation states
Read Automation and Write Automation buttons are fully colored when they affect the entire
channel strip. If only a subset of the channel strip’s controls are affected, the Read Automation
button and Write Automation buttons are only partially colored.
Figure 489. The Read Automation and Write Automation buttons indicate if the entire channel strip is affected,
or only a subset of its controls.
To insert a plug-in effect
Do one of the following:
• Click the Insert FX button in the FX Bin module and choose a plug-in on the pop-up menu.
• Right-click the effects bin and choose a plug-in on the pop-up menu.
To show which channel strips are controlled by a control surface
1. Go to Edit > Preferences > MIDI - Control Surfaces.
2. Select your control surface in the Connected Controllers/Surfaces list.
Tip: To disable automation recording for all write-enabled channel strips, click the Clear all
automation write enables
button in the Control Bar’s Mix module. For details, see “Mix
module” on page 486 .
All controls Individual controls