Reference Guide

1786
View reference
Matrix view
To start a pattern from its beginning
• Make sure the Cell Start toggle is in Always from Beginning mode before you trigger the
pattern.
To configure a cell as “one-shot”
• Right-click the cell and select One-Shot Trigger on the context menu.
The Loop Mode and Latch Mode buttons in the cell are hidden. When One-Shot Trigger mode
is enabled, loop and latch settings are ignored, and the cell only plays one repetition from
beginning to end.
To disable One-Shot Trigger mode, right-click the cell and select One-Shot Trigger on the
context menu.
To synchronize a pattern with the project’s Now time
• Make sure the Cell Start toggle is in Offset to Now Time mode before you trigger the
pattern.
When you trigger a cell in Offset to Now Time mode, the pattern will start playing in sync with the
Now time after the amount of time listed in the Trigger Resolution menu. It’s as if the cell’s
pattern is repeated throughout the song and you unmute the pattern at a certain point.
To synchronize the Matrix with SONAR’s transport
• Make sure the Follow Transport button is enabled.
Patterns will now only play when SONAR’s transport is rolling.
Tip: To trigger a cell using the opposite mode of the current Cell Start setting, hold down the ALT
key when you trigger the cell.
Tip: To trigger a cell using the opposite mode of the current Cell Start setting, hold down the ALT
key when you trigger the cell.