Reference Guide

Controlling playback

Controlling the transport

• MBT. Display time as Measure:Beat:Tick.

• HMSF. Display time as Hour:Minute:Second:Frame. This format is also referred to as

SMPTE time.

• Milliseconds. Display time in milliseconds.

• Samples. Display time in samples.

• Current Tempo. The current tempo at the Now time. Double-click to change the current

tempo.

• Current Meter. The number of beats per measure and the note value of each beat at the

current Now time. Click to change the meter. For details, see “Setting the Meter and Key

signatures” on page 248.

• Metronome Playback on/off . Enable/disable the metronome during playback. Right-click to

access Metronome settings.

• Metronome Record on/off . Enable/disable the metronome during recording. Right-click to

access Metronome settings.

To use the Loop module

Figure 38. The Loop module.

A. Loop On/Off B. Set Loop Time to Select C. Loop Start Time D. Loop End Time

The Loop module contains the following controls:

• Loop on/off . Enable/disable playback looping.

• Set Loop Times to Selection . Set the Loop Start time to the start (From) time of the

selection, and the Loop End time to the end (Thru) time of the selection.

• Loop Start Time. The current Loop Start time. Click to modify.

• Loop End Time. The current Loop End time. Click to modify.

See:

“Track-by-track playback” on page 191

Tip:

If a numeric time field has focus, you can press the G key to access a list of marker positions.