Reference Guide

227
Local control
Controlling playback
3. If there is any track that you want more than one performer to play, create a preset of the input
ports and channels that you want that track to respond to (see previous procedure).
4. Make sure the Input Echo button is on for each track you want to play.
To turn MIDI echo (and input monitoring) on or off for all tracks
Click the Input Echo On/Off All Tracks button in the Control Bar’s Mix module.
Figure 56. The Mix module.
See:
“Local control” on page 227
Local control
You should normally disable the Local Control setting on your master keyboard to prevent notes
from being doubled when you play your keyboard. If you disable Local Control, your keyboard sends
notes that you play to SONAR, which echoes them to the synthesizer, which plays them only once.
When SONAR starts, you can have it send a special MIDI message that attempts to disable Local
Control automatically. Most modern synthesizers respond to this message. If yours does not, you
will need to disable Local Control every time you turn it on for use with SONAR.
To automatically disable all local control whenever you launch SONAR
1. In the directory where SONAR is installed, double-click on the TTSseq.ini file to open it.
2. In the [Options] section, add the line:
SendLocalOff=1
3. Save the file and close it.
4. When you launch SONAR, it automatically sends a Local Off message to your keyboard.
See:
“Playing files in Batch mode” on page 228
Note: Not all keyboards respond to Local Off messages.