Reference Guide

433
Pattern tools
Tools
Using the Pattern tools on automation
Figure 132. Pattern tool hotspots on automation.
See also:
“Tools” on page 389
“Smart tool” on page 404
“Select tool” on page 409
“Move tool” on page 413
“Trim tool” on page 416
“Timing tool” on page 420
“Split tool” on page 423
“Freehand tool” on page 427
“Line tool” on page 430
“Erase tool” on page 434
“Mute tool” on page 438
“Scrub tool” on page 442
“Zoom tool” on page 443
Hotspot Default action
A Draw automation shapes
Table 99. Using Pattern tools on automation
Note: To draw automation shapes, set the Snap to Grid resolution to the desired length of each
pattern cycle, then
perform the following steps in one gesture:
1. Click to set the center position of the shape.
2. Drag up/down to set the vertical range of the shape.
3. Drag left/right to set the duration of the shape.
A