Reference Guide

454
Tools
Using tools to perform common tasks
To move data without moving its clip
1. Set the track’s Edit Filter control to Clips.
2. Do one of the following:
• With the Smart tool , position the pointer within the clip, then hold ALT+SHIFT and drag left/
right to move the data within the clip boundaries.
• With the Trim tool , position the pointer within the clip, then hold ALT+SHIFT and drag left/
right to move the data within the clip boundaries.
To select audio clips
1. Set the track’s Edit Filter control to Clips.
2. Do one of the following:
• With the Smart tool , position the pointer outside any clips, then lasso the clips you want to
select. It is sufficient to simply touch the clips you want to select; there is no need to fully
enclose the clips. Hold down the ALT key and drag to select by time.
• With the Smart tool , position the pointer over the bottom half of the clip, then click to select
the clip.
• With the Smart tool , position the pointer over the top half of the clip, then drag to make a
time selection.
• With the Select tool , position the pointer outside any clips, then drag over the clips you
want to select.
• With the Select tool , position the pointer over the bottom half of the clip, then click to select
the clip.
• With the Select tool , position the pointer over the top half of the clip, then drag to make a
time selection.
• With the Move tool , position the pointer outside any clips, then drag over the clips you
want to select. Hold down the ALT key and drag to select by time.
Tip: To modify a selection, hold down the CTRL key and click clips to toggle their selection state.